Hydraulic disc brake MAGURA MT2...

Hydraulic disc brake Magura MT2 is entry model of whole Magura MT brake family. Perfect brake compare price / power. Brake is made completely from unique material Carbotecture® (lever + caliper). Brake is flip-flop so you can use the lever on left or right side of handlebars.

More details

Reference :MAGBRAKEMT2CARB2FBK

Availability:  In stock!

1 400 Kč
1 157 Kč tax excl.

6 other products in the same category:

- brake lever is made from special Carbotecture® material which was developed by Magura especialy for their unique needs for whole family of Magura MT brakes
- ergonomic brake lever for good touch with which with the high effeciency of power transfer from finger directly to caliper
- easy installation of brake lever where is not necessary remove grips
- smooth movement of lever thanks to Magura Royal Blood mineral oil
- easy bleeding of whole brake system thanks to EBT (Easy Bleed Technology)
- kevlar hose which is pretty durable
- you can mount caliper with Post Mount on your fork or chainstay
- the package comes with IS mount adaptors
- brake is supplied with 220cm long brake hose which you can easily shorten directly for your bike (front or rear brake) - you can find all you need in the package for shortening! If you searching for some help, you can visit Magura oficial manual for instalation.
- brake is supplied filled with oil so you can just pust this brake on bike and you can go
- weight: 245g with whole lenght of hose, (without rotor and supplied mount bolts)

Recommendation:
- we recommend combine this brake with Magura STORM HC rotors, which are available in 160mm / 180mm / 203mm versions
- brake is possible combine with SRAM and SHIMANO shifters (is necessary buy Magura Shift mix)

 

Important informations:

Bleed screw requires very little torque, just a 'nip' into place to seal the brake - maximum 0.5Nm. Damage due to over-tightening is not covered by warranty.

To correctly fit the lever to the handlebar, the bolt with the arrows pointing towards it must be gently tightened first until the gap is closed, then the other bolt should be nipped down. Do NOT tighten this bolt right down, normally there will be a gap of around 2-3mm when the lever is tight on the bars. Over-tightening the bolts or not following this procedure is likely to crack the lever clamp and this is not covered under warranty.


 

 
Jak zkráti brzdovou hadičku můžete shlédnout zde:
 

 

Jak odvzdušnit novou kotoučovou brzdu Magura MT2? Velice snadno:

 

Cena brzdy uvedena za 1ks (kompletní balení).

Cart  

product (empty)